Pouch winder

This device is connected to various three-sided and four-sided seal filling/packaging machines to wind continuous packaging pouches in fixed quantities.


(1) Control panel (2) Pitch detection unit (3) Fixed feed unit (4) Dancer roll unit (5) Winding unit (6) Work table (7) Tension roll

Labor saving effects

Winding of continuous packaging products that is difficult to carry out by hand can be done automatically.


  • Equipment capacity: 70m/min
  • A belt-type feed unit is adopted for transporting pouches. Pouches can be fed without being impacted by packaging materials or tension.
  • Winding with low tension (1[N]) is possible.
  • By adopting our AIREX SHAFT (option) for the winding shaft, the cores can be attached and detached with a single action.
  • The winding shaft is equipped with two shafts. The operation stop time due to reel replacement is reduced, improving productivity.


Winding capacity 70m/min (maximum)
*The maximum capacity will vary depending on the conditions of the packaging materials and contents.
Winding direction Switchable between winding counter-clockwise and clockwise
Pouch specification Width    20㎜ – 100㎜
Length   20㎜ – 90㎜
Winding diameter φ75 – φ550mm
Winding range 20 – 330mm
Inner diameter of
paper tube
φ35mm or larger
Tension 1 – 20[N]
Power supply 3φ AC200V 50/60Hz 1.5kVA